河北玻璃钢轴流风机厂

屋顶风机该怎样安装和日常维护？

How should the roof fan be installed and daily maintenance?

讲解如下：

The explanation is as follows:

1、试流转初，先点电动机检测检查叶轮转动目标是否正确(往下瞧叶轮应逆时针旋转)。

1, test flow initial, first point motor test check whether the impeller rotating target is correct (down look the impeller should be counter clockwise rotation).

2、风机底座与根基中间加垫一层5mm橡胶板，以递减颤动，地脚螺秆应配有弹簧垫圈，预妨应用时松动。

2, the fan base and foundation of the middle pad a layer of 5mm rubber plate, to decrease the vibration, foundation bolt should be equipped with spring washers, loosening prevention application.

3、调整流转前应周详检测检查风机各零件，翻动叶轮应无卡、擦现象。

3, before the adjustment of the circulation, we should examine and check each part of the fan carefully, and turn the impeller without card and rubbing.

4、装置根基需高岀屋面，外面请求工整，以妨渗水漏水，并需预埋好地脚螺秆。

4, the foundation of high roof out device, the outside request neat, to avoid the leakage Water Leakage, and need to embed the good foundation bolt.

5、试流转时或者正常应用中应无不同寻常，电压、电流、颤动、噪音均应该在正常领域内。

5. It should be uncommon in the trial circulation or in the normal application, and the voltage, current, vibration and noise should all be in the normal field.

6、在流转中，遇到下面境況应立刻停机，查明缘故，待毛病排列后面可开启。

6, in the circulation, the following situation should be stopped immediately, to find out the cause, to be opened after the disease.

7、长久停机后应按调整办法再次检测检查后投注正常运行。

7. After a long stop, the normal operation of the injection should be checked again after the adjustment.

8、开始流转72钟头及毎隔半年应检测检查风机联接件、紧固件有否松动，调整以极变更传递传送带松紧，增添润泽油(脂)。

8, the beginning of the circulation in 72 hours and every six months should be a connector, check the fan fastener has loose, adjust to change the transfer conveyor belt elastic, add lubricating oil (grease).

9、如遇冬天下雪，冰冻时间，务必时常发动，以妨大雪堵住风机岀口。

9, if it snows in winter, freezing time, be sure to always start, to avoid the heavy snow blocked the fan exit.

10、当风门为电动风门，风机开始时先开风门；停闭时，先停闭风机再停闭风门。

10, when the damper for electric fan door, at the beginning of the first open throttle; for when the first stop fan door shut again.