玻璃钢离心风机安装前应检查叶轮有无擦碰现象 |
添加时间:2022/5/19 15:38:53 浏览次数: |
玻璃钢离心风机安装前应检查叶轮有无擦碰现象,并对各部件进行全面检查,附件是否完整,部件联接是否紧固。认真检查,玻璃钢离心风机风叶有否因运输损坏或变形,否则应待修复后方可安装。联接风机进出口的风管应当单独的支撑,不允许将管道重量加在风机的部件上,玻璃钢离心风机安装时应注意风机的水平位置,对风机与地基的结合面和出风管道的联接应调整,使之自然吻合,不得强行联接。
Before the installation of the FRP centrifugal fan, we should check
whether the impeller is rubbed or not, and check the components
comprehensively, whether the accessories are complete and whether the
components are fastened. Carefully check whether the blade of the GFRP
centrifugal fan is damaged or deformed due to transportation, otherwise
it should be repaired and installed. Connect the fan inlet and outlet
duct should be independent support, weight of pipe shall not be added in
the wind machine parts, glass steel centrifugal fan installation should
pay attention to the horizontal position of the fan, with the fan and
the ground surface and a connecting duct should be adjusted to fit the
nature, not. Forced connection.
玻璃钢离心风机安装后,用手或杠杆拔动叶轮,检查是否有过紧或控碰现象,有无妨碍转动的物品,在无异常现象下,方可进行试运转,风机传动装置的外露面部分应有防护罩,如风机进风口不接管道时,也需添防护网或其它完全装置。
FRP centrifugal fan is installed, by hand or lever pull impeller,
check whether there is tight or touches the phenomenon, has hindered
rotation of the goods, in no abnormal phenomenon, can test run, fan
drive should be part of the appearance of the protective cover, the air
inlet is not connected to the wind pipe machine also, needed protection
net or other device completely |
上一页 玻璃钢负压风机降温原理 |
下一页 玻璃钢离心风机安装前应检查叶轮有无擦碰现象 |
Copyright © 技术支持:遨游网络